![]() Normalization is modifying the overall amplitude of a sequence based on the level of its highest peak. no higher than human voice, to protect your ears and avoid ear fatigue.ģ – Normalizing/maximizing the volume of a sequence at ear level and equidistant from each other. If you use speakers, place them right, i.e. The human ear can seize 20 to 20,000 Hz-high frequencies, so try to pick a device that covers this range, and choose “studio” or “monitoring” devices, as they do not bring any color to sound (unlike general use devices that may intensify some frequencies, either on purpose or because of cheap composition). You will then be more efficient and make the right postproduction choices. To have a good overview of the outcome, you should work with quality speakers or earphones. Leave a space the size of your hand between your mouth and the microphone, and move as few as possible.īefore editing your sound, make sure you can hear it properly. The microphone input signal should never be over 0 dB Here are the two golden rules to keep in mind: Set your own microphone first, then do the same with you guests’ by making them talk – they can introduce themselves as a warm-up, for instance. Slowly turn the gain up so the signal reaches about -16 dB. Adjust the microphone properly and speak normally. The gain of the microphone cannot be set by ear you must check the input signal of your recorder or interface. ![]() Be careful: the output volume (in the earphones) is nothing like the input volume (microphone), so keep the output volume low enough. Use your earphones while recording and give some to your guests as well if you can, just to hear if one of them is too far from his/her microphone or if a strange noise disturbs the session. Finally, record each participant on separate tracks. Depending on your microphone, consider using a windscreen or an anti-pop filter to protect it from plosives (“p”, “b” and “t” that send air in the cap). Use one microphone per speaker, with a stand or a tripod that would be high enough for the microphone to be in front of their mouths – you will then avoid the noises resulting from holding the microphone. ![]() Go for 44.1 or 48 kHz sample rates (audible frequencies would be lost with lower sample rates) and for 24-bit deep audios (it is better for detail and dynamism). WAV format (not compressed) – you will end up with an mp3 indeed, but you’d rather have a high-quality file when mixing. Here are the life-changing pro tips of a composer, sound designer and sound engineer!Ī quality recording is key for a good final outcome, so get familiar with your device and find the right settings before you start. ![]() You may wonder: what do the best editors do to get closer to perfection? In this article, Morgan, a sound specialist and the Studio Module founder, tries to provide you with an answer. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |